Winco HPS9000VE Instrucciones de operaciones descargar pdf (Pagina 15)

2210-00 60706-237

VanguardEngines.com

2. Checking the Oil Level: The oil level must al-

ways be checked before the engine is started. Take

care to remove any dirt or debris from around the

oilllplugbeforeremoving.Besuretheoillevelis

maintained. Fill to the “FULL” mark on the dipstick.

3. Dual Element Air Filter: Clean and or replace

foampre-cleanerandairlterannuallyorevery100

hours. Service more often under dusty conditions.

WARNING: EQUIPMENT DAMAGE

Never start or run the engine with the air lter re-

moved

a. Loosen snaps (Ref “A”) and remove cover.

Ref “B”

b. Remove the nut (Ref “D”) and the retainer.

(Ref “E”)

c. Removetheairlter.(Ref“F”)

d. Remove the pre-cleaner (Ref “G”) from the air

 lter.

e. Toloosendebris,gentlytaptheairlterona

 hardsurface.Iftheairlterisexcessivelydirty,

 replacewithanewlter.

Notice: Do not use pressurized air or solvents to

cleanthelter.Pressurizedaircandamagethelter

andsolventswilldissolvethelter.

f. Wash the pre-cleaner in liquid detergent and

water. Then allow it to thoroughly air dry.

DO NOT oil the pre-cleaner.

g.Installfoampre-cleanertotheairlter.

h. Installtheairlterandsecurewithretainerand

nut

I Install and secure the cover.

4. Spark Plug: Replace annually or every 100 hours

of operation. Always replace with the same spark

plug that came in the engine and check gap before

installing. Spark plug gap is 0.030”. Poor spark will

alsooccurifsparkplugwiredoesnottrmlyon

sparkplug.Ifthishappens,reformtheterminaltot

rmlyonsparkplugtip.

5. Carbon Canister: Designed to collect, store, and

dispose of fuel vapors created in the fuel tank / fuel

system. The canister should last the life of the unit as

long as it stays dry.

GENERATOR CARE

Proper care and maintenance of the generator is

necessary to ensure a long trouble free life.

1. Exercising The Generator - The generator

should be operated every three to four weeks. It

shouldbeoperatedforaperiodoftimesufcientto

warm the unit up and to dry out any moisture that has

accumulated in the windings. If left, this moisture can

cause corrosion in the winding. Frequent operation

of the engine generator set will also insure that the

set is operating properly should it be needed in an

emergency.

2. Generator Maintenance - Any major genera-

tor service, including the installation or replacement

ofparts,shouldbeperformedonlybyaqualied

electrical service technician. USE ONLY FACTORY

APPROVED REPAIR PARTS.

a. Bearing - The bearing used in these generators

is a heavy duty double sealed ball bearing.

They require no maintenance or lubrication.

b. Receptacles - Quality receptacles have been

utilized. If a receptacle should become cracked

or otherwise damaged, replace it. Using dam-

aged or cracked receptacles can be both dan-

gerous to the operator and destructive to the

equipment.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Winco HPS9000VE Instrucciones de operaciones Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Generadores De Poder Winco HPS9000VE